Avståndssensor och Busser för Adafruit ESP Feather

Från Wikiskola
Version från den 2 december 2019 kl. 22.12 av Hakan (diskussion | bidrag) (Skapade sidan med 'Kodexempel <pre> //Defining the pins and variables const int trigPin = 27; const int echoPin = 13; const int freq = 2000; const int channel = 0; const int resolution = 8; l...')
(skillnad) ← Äldre version | Nuvarande version (skillnad) | Nyare version → (skillnad)
Hoppa till navigering Hoppa till sök

Kodexempel

//Defining the pins and variables
const int trigPin = 27;
const int echoPin = 13;
const int freq = 2000;
const int channel = 0;
const int resolution = 8;
 
long duration;
long distance;
 
void setup() {
  //Initiate serial monitor
  Serial.begin (9600);
 
  //Specifies the pins behavior
  pinMode(trigPin, OUTPUT);
  pinMode(echoPin, INPUT);

  ledcSetup(channel, freq, resolution);
  ledcAttachPin(12, channel);
  ledcWrite(channel, 10);
}
 
void loop() {
  //Sending a LOW pulse to clear the trigPin
  //and sets the trigger to a HIGH pulse for 10 microseconds
  digitalWrite(trigPin, LOW);
  delayMicroseconds(5);
  digitalWrite(trigPin, HIGH);
  delayMicroseconds(10);
  digitalWrite(trigPin, LOW);
 
  //Reads the echoPin and the time it
  //took for the HIGH pulse to return
  duration = pulseIn(echoPin, HIGH);
 
  //Calculating the distance in cm
  distance = (duration/2) / 29.1;
 
  //Checking to see if the discance is less than 400
  //to avoid getting alerts when object is out of range.
  if(distance < 400){
    Serial.print("distance: ");
    Serial.println(distance);
    ledcWriteTone(channel, distance);
  }

  delay(200);
}